BrewYield

Track extract, malt cost and batch performance

Brewhouse efficiency into FV (BHR)

—Enter grist and fermenter readings to calculate.
GristEnter dry extract and moisture from your supplier’s specifications.
Mash
Pre-boil kettle
Use well-mixed pre-boil wort. Kettle volume is corrected to 20 °C.
Last runnings
Residual wort volume is assumed to be measured at 40 °C.
Into fermenter
Advanced · Spent-grain rinse
The workbook suggests about 2 L of rinse water per kg of original grist for its spent-grain test. With total water blank, the rinse estimate assumes 1.56 L/kg of wort retention.
Kettle and transfer residue
Enter leftover wort volume corrected to room temperature and its extract reading. Enter zero volume if no wort remained. The malt cost model assumes no sugar or extract additions after mashing.

Where the malt cost went

Each share uses the grist’s total potential extract. Blank readings leave that share pending.

Batch results

Calculation model adapted from Kai Troester’s Efficiency Analysis Spreadsheet v1.8 (Braukaiser, CC BY-NC 3.0). Fermenter volume is used as entered. Values are estimates and depend on your volume, gravity and malt measurements.